15190 Autoloader ALE: remove plate from picker (slip sheet attached or plate too large Platesetter_3244 Note, no longer use. Open front access door and inspect plate queued on the picker. At the end of the pick sequence when a plate is queued up just above the upper load ramp sensor before searching for the exact plate edge. At this point, if the upper load ramp sensor is covered, then either the plate is bigger than expected or there is a hanging slipsheet attached. ../nvs/al_cal_nlps.xmlNVS: al nlps ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:55 2008 PST